Vaporesso NRG SE Tank Clearomizer ***Out of Stock***
Compact Power - The SE Hits Like a Freight Train & Holds 3.5ml of Liquid!
Available in Black Or Stainless Steel
-Dimensions: 1.875" Tall x .875" Diameter (46 x 22mm)
-510 Threaded
-3.5ml e-Liquid Capacity
-Includes One NRG GT2 Core .4 ohm - 55-65 Watts (Pre-Installed)
-Includes One NRG GT CCELL Core .5 ohm - 15-40 Watts
-Convenient Top Fill Design - No Need to Remove From Battery or Disassemble
-Vaporesso GT Core Atomizer Heads for Variable Wattage or Temperature
-Large Heating Air Tube for High Airflow
-Large Central Airflow Chamber & Dual Adjustable Airflow Slots
-Wide Bore Delrin Driptip
-Stainless Steel & Pyrex Glass Construction
Package Contents:
1 x Vaporesso NRG SE Sub-Ohm Tank 3.5ml
1 x NRG GT2 Core Coil 0.4 ohm Atomizer Head (Pre-installed)
1 x NRG GT CCELL Core .5 ohm Atomizer Head
1 x Replacement Glass
1 x Set of Spare O-Rings
1 x Instruction Manual
The Vaporesso NRG SE Is a Great Compact Tank & Looks Good On Any Mod!
Uses Vaporesso GT Core Coil Units
100% Genuine Vaporesso
Requires Advanced (Mod) Batteries Capable of At Least 30 Watts and Down to the Rated Resistance of the Coil Being Used. Not for Use with eGo/EVOD Batteries.
Advanced devices using higher powered batteries (higher than 20 watts) & subohm (coil resistance of less than 1 ohm) atomizing devices will produce more vapor & deliver the nicotine much more efficiently. We highly recommend using liquid with a maximum strength of 12mg with these devices. Most users of these devices find that 0-6mg is optimal.
There is NO Warranty on Cartomizers or Clearomizers for Any Reason. Returns/Exchanges Are NOT Accepted for Any Reason.
To Fill/Refill: 1) Pivot Top of Tank Counter Clockwise to Expose Filling Slot
2) Add Liquid in Oval Slot, Do Not Add to or Get Liquid in the Center Tube
3) Pivot the Top of Tank Clockwise to Close
REFILL THE TANK WHEN OR BEFORE THERE IS ABOUT 1/4 LEFT IN THE TANK. Running the clearomizer without sufficient e-liquid is the primary cause of premature failure.
To Replace Coil Unit:
1) Remove Tank From Battery
2) Hold Tank Upside Down with Mouthpiece Facing Down, Turn Base Counter Clockwise to Remove From Tank
3) Turn Coil Core Counter Clockwise to Remove From Base, Thread New Coil Core to Base Secure Snugly But Do Not Overtighten
4) Thread Base Back on to Tank
5) Fill Tank & Replace the Assembled Tank to the Battery and Allow the Liquid to Soak In for About 10-20 Minutes on First Fill & About 2-3 Minutes on Subsequent Refills & You're Ready to Go!
|
Excellent 
Amazingly fast service! 